Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 64)

TheaterTouch Designer

RP6 RELAY CONTROL EXAMPLES

The three relays in the RP-6 can provide contact closure or switching control for loads up to 3A/30VDC each.

All three relays are Normally Open when not energized, but they can be programmed to behave Normally

Closed as long as power is applied to the RP-6.

12V TRIGGER EXAMPLE

To use a relay as a voltage trigger, connect the positive side of a power

supply to CONTACT A, and connect CONTACT B and the ground side of

the power supply to the desired device. If the desired trigger voltage is

+12VDC, it can be sourced directly from the RP-6.

CONTACT CLOSURE EXAMPLE

For contact closure control, simply connect the A and B contact terminals

of a relay to the desired device.

RP6/RP1 FLAG NAMES TAB

1. Input the names of the flags to be associated with this device in a Flag

Macro Step.

Note: Flags are used in macros to keep track of a component or

remote device's status and act based on that status. For example,

you can use this functionality to make discrete power ON and OFF

macros for components for which you have only toggle codes. Flags

exist on a per-device basis, therefore you must name each flag used

by each remote device or contol processor. (See Working with Macros

- Chapter 8 for more information on programming macros using Flags).

2. Choose OK to confirm the new settings.

RP6/RP1 NOTES TAB

1. Enter any device specific notes for future reference.

Note: This field does not affect the functionality of the device, it is for

your informational purposes only.

2. Choose OK to confirm the new settings.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 64