Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 36)

TheaterTouch Designer

RK3 OUTPUT TAB

DEFAULT OUTPUT MODE

1. Change the default output mode by selecting one of the

two available options listed

Note: To have any single button on the device operate in

a different output mode or trigger a different control pro

cessor from the device default, you must edit the Button

Properties Output Tab (See Output Tab - Chapter 6 for

more information on editing a buttons properties).

STANDALONE

In-wall control devices are set to the Standalone output

mode by default when a control processor is not includ

ed in a system file. In this mode, devices output IR

commands and issue macros to components directly.

IR TRIGGER CODES FOR CONTROL

SYSTEM

In-wall control devices are set to the IR Trigger Codes

for Control System output mode by default when a

control processor is included in a system file. In this

mode, devices send IR trigger codes to the control

processor which outputs IR commands and macros,

and also provides access to additional features such

as RS-232 commands, IR routing, power sensing and

relay control.

2. Choose which control processor a device triggers by default (all control processors included in the system file are

displayed for selection in the drop down list.)

3. Adjust the IR Trigger Code carrier frequency to improve IR trigger code reliability when using an IR receiver and

a control processor.

4. Choose OK to confirm the new settings.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 36