Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 44)

TheaterTouch Designer

T4 NETWORK TAB

Use the Network(100BaseT) tab for hardwired Ethernet when using the EM4 Expansion

Module. Use the Network(WiFi) tab to use the built in wireless networking adapter for

wireless Ethernet.

DHCP

1. Check this box to configure the device's network interface using DHCP.

You must have a DHCP server (such as a router or cable/DSL modem)

on the network for this to work. In most cases, this is the option you

should use.

MANUALLY CONFIGURE NETWORK SETTINGS

2. Use this selection to configure the device's network interface using a

static IP address. The values can be obtained by contacting your ISP or

your network administrator.

- Enter the device's static IP Address

- Enter the network's:

Netmask

Gateway IP Address

DNS Server 1

DNS Server 2 (If only one is available, leave blank)

ALLOW THE DEVICE TO BE PROGRAMMED OVER THE NETWORK

3. Check this box to allow the device to be programmed remotely via the device's ethernet interface. If

you uncheck this box you will have to use a direct USB connection to update the device's programming.

Unchecking this box provides increased security by preventing the device's programming from being altered

over the network.

4. Select OK to confirm all selections.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 44