Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 130)

130

TheaterTouch Designer

USING THE CHANNEL MACRO WIZARD - Continued

The next step defines any "boilerplate" commands that must be inserted before or after each macro. In this example,

the cable box requires the "Ok/Select" button to be pressed after the channel numbers are entered, so the "Ok/Select"

command is placed in the ‘Do this AFTER each macro’ list. If you need to select a specific TV/Processor/Preamp/etc.

input before each channel, or send commands to control an IR switcher, the ‘BEFORE’ list is a good place to put

the command.

The ‘BEFORE’ and ‘AFTER’ lists are full-fledged macros, and can contain commands from other remotes/libraries as

well as time delays and other special commands.

1. Select the Add/Edit button in the BEFORE or AFTER sec-

tion if you choose to add commands. This will open the

Macro Editor where you can select the commands using

the Macro Editor commands. If you need help with these

commands, see the “Using the Macro Editor” section.

The final step in using the Channel Macro Wizard is to create the individual macros. To create each macro, use the

following procedure:

1. Choose the pages that contain the channel buttons from

the pull-down menu, we are creating macros for the

"Favorites" page.

2. Choose a button for which to create a macro. Here we

have chosen the "Fox" button. If there is a macro on this

button already it will be displayed in the existing macro

window.

3. Use the number buttons on the right to enter the channel

number (111 in this case).

4. Click the save button.

5. Repeat steps 2-4 for each macro you wish to create.

6. When you have created all of the macros you need, click the Close button.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 130