Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 122)

122

TheaterTouch Designer

USING THE MACRO EDITOR - Continued

The Stop Macro step causes the

macro to stop executing at the

point where it is inserted.

Macros automatically stop when they reach the end, so you

should not normally need to insert a Stop Macro step. It is

intended for use in conjunction with the Button Test step, where

you can have the macro stop if a condition is met.

The Repeat Steps step causes

the macro to output a group of

steps multiple times. Set the options to continuously repeat the

following macro steps for as long as the button is held down or

to have the steps the indicated number of times. You can enter

any repeat count from 1 to 60.

This step is used most often to sustain an RS232 command.

(System Control Processor

must be present)

The Status Test step causes the macro to execute or not execute

a group of steps based on the status of an input or output line.

Select the input or output line you would like to monitor from

this list then select the condition you would like to check for on

the selected input/output line.

Note: This option requires either an RP-6 along with a VPS-1

or SPS-1, or an RP-1 which tests the status of it's built-in power

sensor.

(Standalone Mode Only)

The Beep step causes the device

sound an internal beeper. The beeper will sound regardless of the

Enable Beeper setting in the Device Properties dialog.

Check the wait for the sound to finish check box to make the

macro stop before moving on to the next step. If this box is not

checked, the sound will play while the macro continues to run. If

this box is not checked and the device is already playing a sound,

this sound will be skipped.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 122