Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 43)

T4 OUTPUT TAB

DEFAULT OUTPUT MODE

1. Change the default output mode by selecting one of the two

available options listed

Note: To have any single button on the device operate in a

different output mode or trigger a different control processor

from the device default, you must edit the Button Properties

Output Tab (See Output Tab - Chapter 6 for more information

on editing a buttons properties).

STANDALONE

In-wall control devices are set to the Standalone output

mode by default when a control processor is not included

in a system file. In this mode, devices output IR commands

and issue macros to components directly.

IR TRIGGER CODES FOR CONTROL SYSTEM

In-wall control devices are set to the IR Trigger Codes for

Control System output mode by default when a control

processor is included in a system file. In this mode,

devices send IR trigger codes to the control processor

which outputs IR commands and macros, and also pro

vides access to additional features such as RS-232 com

mands, IR routing, power sensing and relay control.

2. Choose which control processor a device triggers by default (all control processors included in the system file are

displayed for selection in the drop down list.)

3. Adjust the IR Trigger Code carrier frequency to improve IR trigger code reliability when using an IR receiver and

a control processor.

4. Choose OK to confirm the new settings.

Chapter 4. Working with Devices

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 144 145

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 43