Escient FireBall H-40 Remote control Manual de usuario descargar pdf (Pagina 3)

FIREBALL REMOTE CONTROL GUIDE WD006-1-1

12/23/2003

6325 Digital Way Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com

Controlling Multiple FireBalls with 1 Remote

Every FireBall is preset from the factory to operate from the FB source button, however, the

FireBall can be configured to use any one of the three Escient source buttons using the on

screen Setup menus. This is useful when there are multiple FireBalls installed at the same

location, so all FireBalls don’t respond to the same IR commands. Use the following steps to

change which source button (FB, TB, or PP) each FireBall will listen for commands from:

 Press the Setup key on the remote to display the FireBall setup menu.

 Highlight and Select the Utilities menu item.

 Highlight and Select the IR Remote Control menu item.

 Highlight and Select which source button to use to control this FireBall.

 Press the new source button on your remote to reconfigure the remote and confirm the

change by selecting the OK button on screen.

Repeat these steps for each FireBall in your system, selecting a different FB button for each.

Resetting the FB, TB, and PP Source Buttons

The FB, TB, and PP source buttons are preprogrammed at the factory with the correct codes

to control a FireBall H/E, a TuneBase 200, and a PowerPlay. If you changed these buttons to

control other devices, you will have to reset the FB, TB, or PP source buttons back to the

original codes in order to control the original device again. Use the following steps to program

these buttons back to their factory states:

 Press the FB, TB, or PP source button to be re-programmed.

 Press & Hold the “Code Set” button on the remote until the LED flashes twice.

1 2 3 4 5 6 7 8 ... 18 19

Sin comentarios

Escient FireBall H-40 Remote control Manual de usuario Pagina 3